Engine; Engine Oil Exchange; Clutch; Steering - Zipper Maschinen ZI-MD500HSN Betriebsanleitung

14.5

Engine

Information about engine maintenance you can find in operation manual of the engine
manufacturer!
14.5.1

Engine oil exchange

The engine oil change would be explicitly mentioned here in order to be included in the
machine operating manual. Oil change interval after the first 20h or 1 month after
commissioning and then every 100h or 1x per year.
14.6

Clutch

As clutch wears out, the same lever could have a wider opening, being so uneasy to use. To
enable proper operation, the clutch cable must be adjusted:
14.7

Steering

If you have difficulty steering the unit, you will need to adjust the steering levers with the
special adjusters.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HSN
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T I C E
Waste oils are toxic and must not be released into the
environment! Contact your local authorities for information on proper
disposal.
1. remove the oil drain plug (1) from the engine.
2. open the oil tank cap (2). Collect the draining oil
3. retighten the oil drain plug after draining.
4. Fill in fresh oil through the filling opening (3) (see
5. Use only high quality engine oil, e.g: SAE30,
1. Loosen the jam nut (1) by turning it counter clockwise with
10 mm wrench.
2. The clutch lever is set to the original position with the
adjusting nut (2).
3. Then retighten the lock nut (1).
1. Loosen the jam nut (3) by turning it counter clockwise with
10 mm wrench.
2. Unscrew the adjust nut (4) to eliminate the play in the
cable, which can occur after initial use or normal wear. Be
very careful not to unscrew the adjust nut too much
because this can create another problem: the loss of
traction.
3. Then retighten the lock nut (3).
in a collection container and dispose of it properly.
section Checking the engine oil level).
15W40 or similar!!
N O T I C E
Drain the used oil when the engine is
warm. Warm oil drains quickly and
completely.
41