Werbung
Verfügbare Sprachen
Verfügbare Sprachen
G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep
these instructions in a safe place for future reference. If you sell the device, please pass
these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
• Tabletops (2x)
• Swivel castors (4x)
• Mounting rods (3x)
• Installation kit (Content see illustration)
• Star base (1x)
• These operating instructions
Note
Please check that the installation kit is complete before installing the projector table,
and ensure that none of the parts are faulty or damaged. You will also require a
screwdriver to assemble the projector table. This is not included in the scope
of delivery.
3. Safety Notes
Warning
• Never apply force during assembly. This can damage your terminal
device or the product.
• Once you have assembled the projector table, it is important to check that it is
sufficiently stable and safe.
• In the event of damage, remove any devices and discontinue use of
the projector table.
• Ensure that electrical cables are not crushed or damaged during assembly.
• Place the product only on flat, non-slip surfaces that can bear the weight of the product
and the device placed on it.
• Do not overload the product beyond the load bearing capacity
• Make sure that the product is loaded symmetrically.
• Check the general operational safety regularly, and make sure that the product and the
device attached to it are positioned securely.
• You should repeat this check at regular intervals (at least every three months).
• In the event of damage to the product, remove the attached load and stop using the
product.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
• Do not modify the product in any way. Doing so voids the warranty.
• Do not allow children to use the product for climbing.
• Do not attach any other objects to the product.
Note
Note that the swivel castors of the product may cause pressure marks on the surface on
which the product is positioned. This will depend on the weight load and the stability
of the surface where the product is located.
Note – Commercial use
• If the device is used commercially, increased duty of care requirements apply.
• Therefore, please observe the accident prevention regulations of the German
employer's liability insurance association for electrical systems and equipment.
Please also observe all accident prevention regulations from other applicable
employer's liability insurance associations and accident insurance companies, as
well as any legal regulations applicable to the particular industry and/or location.
• The bracket must be installed by trained personnel or by a special technician,
especially when installed in schools, educational institutions, hobby/self-service
workshops or other publicly accessible institutions.
• Secure the product and the attached load against falling using suitable equipment
(e.g. an arresting cable) and in accordance with locally applicable regulations.
2
Note – Commercial use
• We strongly recommend these additional safeguards even if they are not legally
• Have trained personnel carry out regular inspections to ensure that the product
4. Intended use and specifications
• The product is intended for storing projectors, laptops, tablets and documents, etc.
• Only use the product for the intended purpose.
• The product is intended for indoor use only.
Load capacity of the
compartment bottom ½:
Table angle:
Dimensions of table 1/table 2: 42 x 50 cm/ 40 x 35 cm
Height of table 1/table 2:
5. Installation requirements and installation
Note
• Ensure that no electrical cables are crushed or damaged during installation or
• Once you have mounted the product and the attached load, check that they are
• Observe the other warnings and safety instructions.
• Proceed step-for-step in accordance with the illustrated installation instructions
(fig. 1 to fig. 16).
6. Adjusting the height and angle
Warning
• Remove all devices from the projector table before adjusting the
• During adjustment, ensure that the product is loaded symmetrically and that the
specified.
Table 1 (upper platform)
• Slightly loosen the knurled screw on the upper platform.
• Move the pull-out bar to which the platform is attached to the
required height position or adjust the angle of the platform.
• Hand tighten the knurled screw again.
Table 2 (lower platform)
• Slightly loosen the knurled screw on the lower platform.
• Slide the platform to the required height position or adjust the angle of the platform.
• Hand tighten the knurled screw again.
7. Setting and maintenance
• Always fix the castors by means of the stop brakes once the
projector table has been positioned as desired.
• Check that the bracket is secure and safe to use at regular intervals (at least every three
months). Only use water or standard household cleaners for cleaning.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting
from improper installation/mounting, improper use of the product or from failure to observe
the operating instructions and/or safety notes.
required.
is securely installed, properly functioning and in acceptable condition (we
recommend inspections at least every 6 months, or more frequently if required for
the particular location) and then document these inspections.
je 10 kg
– / + 35°
85 - 110 cm/ 70 - 95 cm
adjusting.
sufficiently secure and safe to use.
height and angle.
maximum permitted carrying capacity is not exceeded.
Werbung
