Use - Elite SANREMO Universal Bedienungsanleitung

GB
Open the quick fastener of the rear support (fig.10)
and, with the antitheft key, the cover of the front
support (fig. 11).
Remove the front wheel from the bicycle and place
the rear wheel on the cradle of the rear support
(fig. 12 e 13).
Insert the ends of the bicycle fork on the 2 pins
of the front support, making sure that they fit
freely and without any hindrance (fig. 14). If there
is not enough space for the fork ends, turn the
fine adjustment wheel (located inside the front
support) in the direction of the arrow (fig.15),
14

USE

Fig.10
Fig.11
Fig.12
Fig.13
moving the two pins to the outside until the ends
of the fork can enter freely (fig. 16).
With front support cover still completely open,
turn the fine adjustment wheel in the direction of
the arrow (fig. 17) until the clearance between the
inner surfaces of the front support pins and the
fork ends is minimum when the cover is at approx.
45° (fig.18 and 19). If the clearance between the
parts is greater or less than that described, repeat
the fine adjustment operation, until the correct
tightening torque is applied.
Fig.14
Fig.15
Fig.16
Fig.17