OrCam Read Erste Schritte Seite 9

Reading Navigation.
- To pause or resume reading, press the trigger button twice.
- To skip to the next sentence, press the plus ("+") volume button
once.
- To go back to the previous sentence, press the minus ("-")
volume button once.
- To stop reading, press the trigger button once.
- When OrCam Read is finished reading, it will make a chime
sound.
Laser Pointer Modes.
You can switch the laser pointer mode by pressing the plus and
minus volume buttons at the same time.
There are two laser pointer modes:
- "Border" for reading framed text.
- "Mouse" to start reading at a specific location.
Note: OrCam Read captures the selected text within 5 seconds
of pressing and holding the trigger button. If your finger is not
released before 5 seconds transpire, the camera will not activate
Set Zone and Time & Telling the Time and Date.
1.
To set the internal clock, go to the Time Set page on the
website: www.orcam.com/timeset.
2.
Press the trigger button to read the "OrCam Please Set Zone
and Time" command on the screen.
3.
There are two ways to hear the current time:
- Rapidly press the trigger button twice and say after the long
beep, "Tell the time".
07.
- Use the mouse laser pointer to read the following command:
OrCam Please Tell Time
4.
There are two ways to hear the day of the week and the date:
- Rapidly press the trigger button twice and say after the long
beep, "Tell the date".
- Use the mouse laser pointer to read the following command:
OrCam Please Tell Date
5.
After a few seconds, OrCam Read will tell you the current time
and/or date.