OrCam Read Erste Schritte Seite 8

2. On your OrCam Read:
A. Connect OrCam Read to the charger.
B. Hold OrCam Read in front of the screen (computer screen
about 12-16 in [30-40 cm]; smartphone screen about 6-8 in [15-
20 cm]) in order to scan the QR code.
C. Read the QR code either using a vocal command or manually.
- Rapidly press the trigger button twice and say after the long
beep, "Read the QR code".
- Point OrCam Read at the OrCam Please command and the QR
code on the screen. Press the trigger button.
D. OrCam Read will chime and make several beeps as it scans
the QR code and connects to the WiFi network. It will announce
when it is connected.
Note: To check the status of your OrCam Read's
connectivity to the internet, rapidly press the trigger button twice
and say after the long beep, "Check the internet connectivity".
OrCam Read
Features.
Reading with the Trigger Button.
1. Hold OrCam Read steady, directly facing the text at a distance
of about 6-14 inches (15-35 cm) away from the text. Make sure
that the long side of the device with all of the buttons is facing
upward.
2. There are two ways to read with the trigger button.
- Press the trigger button once to take a picture of all text that is
present.
- To read more specific text, use the laser pointers.
06.
A. Press and hold down the trigger button, which will activate the
laser indicator and a border laser frame or mouse laser pointer
will be projected onto the text.
B. Adjust the border laser frame or mouse laser pointer in order
to capture the desired text.
C. Let go of the trigger button. You will then hear a camera shut-
ter sound as OrCam Read takes a picture of the text.
3. OrCam Read will make several beeps as it processes the
text. It will then begin reading the text and chime when finished
reading.
Note: If your finger is not released before 5 seconds transpire, the
camera will not activate.