OrCam Read Erste Schritte Seite 12

(v) the product has been combined with software, hardware, or other equipment not supplied by OrCam or not approved in writing by an authorized
OrCam representative
(vi) the product has been intentionally damaged or exposed to water, heat, or high voltage
(vii) the product has been used by a person who has not completed training by an authorized OrCam Trainer
Any parts replaced pursuant to this warranty will be under warranty for the remaining time of the original warranty period or for ninety (90) days
from the date of repair, whichever is longer.
To register your device for warranty, please visit the warranty registration website: https://discover.orcam.com/warranty.
If you believe that your product needs warranty support, contact support@orcam.com. You will be responsible for shipping costs. However, if it is
determined that the warranty request is valid, OrCam will pay the total cost of shipping the repaired or replaced product.
ORCAM DISCLAIMS ANY AND ALL WARRANTIES, WHETHER EXPRESSED OR IMPLIED, INCLUDING WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF NON-INFRINGEMENT OF THIRD-PARTY RIGHTS, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. ORCAM
DOES NOT WARRANT THAT THE PRODUCT WILL BE ERROR FREE OR "BUG" FREE, WILL OPERATE WITHOUT INTERRUPTION, THAT ANY IMAGES
OR SOUNDS PRODUCED BY THE PRODUCT WILL BE ACCURATE OR THAT THE OPERATION OF THE PRODUCT WILL BE SECURE AND HEREBY
DISCLAIMS ANY AND ALL LIABILITY ON ACCOUNT THEREOF. THIS SECTION SHALL BE ENFORCEABLE TO THE FULLEST EXTENT ALLOWED BY
APPLICABLE LAW.
Refund Policy.
You can return your undamaged device for a refund within the period required by local law or as agreed between you and OrCam at the time of
purchase. Training fees are non-refundable. Please contact your local representative or OrCam Support to initiate a return process.
When you return the OrCam device, please follow OrCam Support instructions carefully. The device must be in the same condition that you
received it and undamaged in any way. Your refund and how it is issued may differ based on how the device was purchased, its condition, and how
long you've had the device.
OrCam will process your return only after the carrier has received your device and delivered to OrCam. It usually takes up to three weeks for OrCam
to receive (for international shipping involving local customs it may take longer) and process your return. Once OrCam issues your refund, it may
take additional time for your funds to be made available in your account by your financial institution. For credit card payments, it may take 5 to 10
business days.
If you have any questions, please feel free to contact the OrCam Support team.
TM
FCC Compliance.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician.
- This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Warning.
Modifications not expressly approved by the manufacturer could void the user authority to operate the equipment under FCC Rules.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
10.