Maintenance - Makita Rp0910 Bedienungsanleitung

Connecting to Makita vacuum cleaner
Fig.15
Cleaner operations can be performed by connecting the
tool to Makita vacuum cleaner.
Insert the nozzle assembly and the dust nozzle
assembly into the tool. Also, the dust nozzle assembly
can be inserted into the tool base directly in accordance
with the operation.
When connecting to Makita vacuum cleaner (Model 407),
an optional hose 28 mm in inner diameter is necessary.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.16
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.17
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Templet guide 25
•
Templet guides
•
Lock nut
•
Collet cone 1/4"
•
Collet cone 6 mm, 8 mm
•
Downloaded from www.Manualslib.com
accessories or attachments
persons. Only use accessory or
manuals search engine
Wrench 8
•
Wrench 17
•
Dust nozzle assembly
•
Nozzle assembly
•
Router bits
Straight bit
Fig.18
D
20 6
20E 1/4"
8 8
8 6
8E 1/4"
6 6
6E 1/4"
007136
"U"Grooving bit
Fig.19
D
6 6
6E 1/4"
007137
"V"Grooving bit
Fig.20
D A
1/4" 20
006454
Dovetail bit
Fig.21
D
15S 8
15L 8
12 8
007138
are
Drill point flush trimming bit
Fig.22
D
8 8
6 6
6E 1/4"
007139
9
A L 1 L 2
20 50 15
8 60 25
8 50 18
6 50 18
A L 1 L 2 R
6 60 28
mm
L 1 L 2
50 15 90
A L 1 L 2
14.5 55 10 35
14.5 55 14.5 23
12 50 9 30
A L 1 L 2 L 3
8 60 20 35
6 60 18 28
mm
mm
3
mm
mm