Declaration Of Conformity; Service; Troubleshooting - Protool SSP 200 EB Originalbetriebsanleitung/Ersatzteilliste

14 Declaration of Conformity

Sword saw
SSP 200 EB
We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents:
EN 55 014-1, EN 55 014-2, EN 60 745-1, EN 60 745-2-13,
EN 61 000-3-2, EN 61 000-3-3 according to the
provision of the regulations stipulated in Directive
2006/42/EC, 2004/108/EC, 2000/14/EC.
All the procedures were applied as validly amended
at the time of the issue of this declaration, without
quoting these.
Technical documentation is kept at the manufac-
turer.

15 Service

Any repairs during and after the warranty period shall be performed by the service centres listed.

15.1 Troubleshooting

Problem
The machine will not run
The cut is not clean; the chain
goes to the side
Strong force required to move
the machine into the cut
The chain is not lubricated
Downloaded from www.Manualslib.com
Serial no.
Cause
No power supply
Worn brushes
Stuck switch
When overloaded
Moves into cut too far
Blunt tool
The chain is not sharpened
properly
The supporting area of the runner
is dirty
Blunt tool
Different qualities of wood
Moves into cut too far
Blocked lubrication grooves on the
guide bar
Defective oil feed pump
Empty oil reservoir
The machine's inner oil channels
are clogged or the bio oil has
solidifi ed
manuals search engine
638557
11
Stanislav Jakeš
Research and development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
31. 1. 2011
Solution
Check the safety fuses and the
power cords
Replace the brushes
Press the unblocking button
Check the safety fuses
Reduce the movement
Sharpen the chain or replace it
with a new one
Replace the chain with a new
one
Clean it
Sharpen the chain or replace it
with a new one
Adjust the size of the movement
into the cut
Reduce the movement
Clean the guide bar
Replace the pump (at an
authorised service centre)
Replenish chain oil
Clean the machine (at an
authorised service centre)
29