Werbung
Verfügbare Sprachen
Verfügbare Sprachen
®
LCD Colour Monitor
GB
1 Operating Elements and Connections
1 Speaker openings
2 Threaded jack for fixing the support to the lower
side of the monitor
3 Slidable hexagon nut for fixing the support to the
rear side of the monitor
4 Mini DIN inline jack for connecting the supplied
cable
5 Button to select one of the two video inputs
button disengaged: video input 1
(normal picture)
button pressed:
video input 2
(mirror-inverted picture)
6 Brightness control
7 Control for the colour intensity
8 Volume control
9 POWER switch
2 Safety Notes
The monitor and the supplied plug-in power supply
unit correspond to the directive 89/336/EEC for elec-
tromagnetic compatibility. The power supply unit addi-
tionally corresponds to the low voltage directive
73/23/EEC.
Attention! The power supply unit is supplied with
hazardous mains voltage (230 V~). Leave servicing
to skilled personnel only. Inexpert handling may
cause an electric shock hazard. Furthermore, any
guarantee claim will expire if the power supply unit or
the monitor has been opened.
It is essential to observe the following items:
The monitor and the power supply unit are suitable
for indoor use only. Protect them against dripping
water and splash water, high air humidity, and heat
(admissible ambient temperature range 0 – 40 °C).
Do not set the monitor into operation, and immedi-
ately disconnect the power supply unit from the
mains socket if
1. there is visible damage to the monitor or to the
power supply unit,
2. a defect might have occurred after a drop or simi-
lar accident,
3. there are malfunctions.
The units must in any case be repaired by skilled
personnel.
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
No guarantee claims for the power supply unit or the
monitor and no liability for any resulting personal
damage or material damage will be accepted if the
power supply unit or the monitor is used for other
purposes than originally intend-ed, if they are not
correctly connected, operated, or not repaired in an
expert way.
If the power supply unit and the monitor are to be put
out of operation definitively, take them to a local
recycling plant for disposal which is not harmful to
the environment.
3 Applications
This LCD colour monitor in TF T active matrix technol-
ogy is equipped with two video inputs and an audio
input and offers a sharp, high-contrast, and fast picture
presentation. The picture of video input 1 is normally
presented, the picture of video input 2 is vertically
mirror-inverted. For the audio reproduction a small
speaker has been installed.
The monitor is suitable for universal applications,
e. g. in video surveillance systems or for multimedia
applications. A support including mounting screws, a
®
Copyright
TVLCD-566COL
1
plug-in power supply unit for the mains operation of
the monitor, and an adapter cable for connecting the
monitor to a 12 V current source are included in the
scope of delivery.
4 Installation/Mounting
With the supplied support the monitor can be set up or
fixed to a wall. However, it can also be mounted to
another support with thread [6.3 mm (
1) Tightly screw the support to the monitor. Depending
on the desired angle of view, either use the thread-
ed jack (2) at the lower side of the monitor or the
hexagon nut (3) slidable in the guide rail.
2) For setting up the support, it can tightly be mounted
with the three supplied screws for a better stability
or be glued by removing the foil on its lower side.
For wall mounting tightly screw the support with the
three supplied screws to the wall.
3) Release the lateral setscrew at the support, adjust
the desired monitor inclination, and tighten the set-
screw again.
5 Connection
1) Connect the mini DIN plug of the supplied cable to
the inline jack (4) of the monitor cable.
2) It is possible to connect two video sources (cam-
eras, DVD players, etc.):
a Connect the yellow phono plug to the video out-
put of the first video source.
b Connect the black phono plug to the video output
of the second video source.
3) It is possible to connect a separate audio source or
the audio output of one of the two video sources to
the audio input (white phono plug).
4) In case of power supply via the 230 V mains
connect the supplied plug-in power supply unit to
the red low voltage inline jack of the cable and to a
mains socket (230 V~/50 Hz).
Via the supplied adapter cable the monitor can
also be connected to another current source which
supplies an operating voltage of 12 V
current rating of 500 mA (e. g. 12 V battery).
©
by MONACOR INTERNATIONAL GmbH & Co. KG, Bremen, Germany. All rights reserved.
Order No.
19.9680
2
3
4
6 Operation
1) To switch on the monitor, press the switch ON/OFF
2) Select the video input with the button L/R (5):
1
/
")].
4
3) With the brightness control BRIGHT (6) and the
4) Adjust the volume with the VOLUME control (8).
5) To switch off the monitor, disengage the switch ON/
7 Specifications
Screen: . . . . . . . . . . . . . . TFT active matrix, screen
Colour system: . . . . . . . . PAL
Resolution: . . . . . . . . . . . hor. 960 x vert. 234 pixels
Video inputs:. . . . . . . . . . 1 Vpp/75 Ω
Audio input: . . . . . . . . . . 30 mV/10 kΩ
Audio output power: . . . . 0.5 W
Ambient temperature:. . . 0 – 40 °C
Power supply:. . . . . . . . . 12 V , 500 mA
Connection cable
Dimensions: . . . . . . . . . . 155 x 120 x 35 mm
Weight: . . . . . . . . . . . . . . 450 g
According to the manufacturer.
and has a
Subject to technical modification.
(9) so that it locks into place.
button disengaged:
video input 1 (normal picture presentation)
button pressed:
video input 2 (picture vertically mirror-inverted)
control for the colour intensity COLOR (7) adjust an
optimum picture.
OFF (9) again.
diagonal 14.2 cm (5.6")
MAX
Video 1: . . . . . . . . . . . yellow phono plug
Video 2: . . . . . . . . . . . black phono plug
Audio: . . . . . . . . . . . . . white phono plug
Power supply:. . . . . . . red low voltage inline jack
for a plug of the dimen-
sions 5.5/2.1 mm
(Ø outside/inside)
A-0248.99.01.07.2004
®
5
6
7
8
9
Werbung
