VOLTCRAFT 1362463 Bedienungsanleitung Seite 2

OPERATING INSTRUCTIONS
USB CHARGER
ITEM NO.: 1362463 SPAS-2400/2+
ITEM NO.: 1362464 SPAS-4800/4
INTENDED USE
The product is suitable for charging and operating two (order no. 1362463) or four (order
no. 1362464) USB devices simultaneously. Power is supplied via a normal household power
outlet. The product features overload and short circuit protection mechanisms.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you
use the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, fire, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
DELIVERY CONTENT
• USB charger
• Operating instructions
SAFETY INSTRUCTIONS
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in theses operating instructions, we assume no liability
for any resulting personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
• is visibly damaged,
• is no longer working properly,
• has been stored for extended periods in poor ambient conditions or
• has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Always turn off the connected device before connecting/disconnecting it.
• Disconnect the product from the power outlet and the USB device when it is not
in use.
• The product gets hot during use. Ensure sufficient ventilation and never cover the
product during use.
• Do not short-circuit the USB outputs.
• Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product.
The plug-in power supply unit also involves danger to life by electric shock! Allow
the device to reach room temperature before connecting and using it. This may
take several hours.
• Never leave the product and the connected device unattended during use.
• Only connect the power adapter to a normal mains socket connected to the public
supply. Before plugging in the power adapter, check whether the voltage stated on
the power adapter complies with the voltage of your electricity supplier.
• Never connect or disconnect power adapters if your hands are wet.
For safety reasons, disconnect the power adapter from the mains socket during
storms.
b) Miscellaneous
VERSION 08/15
• Consult a professional if you require assistance with product operation, safety or
connection.
• Maintenance work, adjustments and repairs may be carried out only by a
professional or at a specialist workshop.
Should you have questions concerning correct product connection or operation, or should
other questions arise that this user manual does not address, please do not hesitate to
contact our technical support or a third-party professional.
OPERATION
Always turn off the desired device before connecting it to the USB port.
Make sure the connection is correct. If the product is not connected properly,
it could overheat or cause an electric shock or fire.
Make sure that your device meets the product's power requirements (see
technical data).
You can charge or operate multiple USB devices simultaneously using the product. How
to connect a single USB device is described below.
The current output of one USB port must not exceed 2400 mA. The total current output
of all USB ports must not exceed 4800 mA.
You may also connect two separate USB devices with a current consumption
of 2400 mA each to the product. The other USB ports must remain unconnected in such
a case (if other ports are available).
1. Connect the switched-off USB device to the product.
2. Connect the product to a common household power outlet. The power indicator on the
product lights up to indicate the product is operational.
3. Your USB device is now charging. Should you wish to operate the USB device, you may
turn it on now.
4. Turn off the USB device before disconnecting the product from the power outlet.
5. Unplug the product after use.
CLEANING
Disconnect the product from the power outlet before cleaning. Clean the product with a dry,
fiber-free cloth.
DISPOSAL
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the relevant
statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
TECHNICAL DATA
Input voltage ................................................ 100 – 240 V/AC, 50/60 Hz, 520 mA
Output voltage / current ............................... 5 V/DC, 2 x 2400 mA (Item no.: 1362463)
Output power (total) ..................................... max. 24 W
Operating conditions .................................... 0 to +35 ºC, 20 – 85 % RH (non-condensing)
Storage conditions ....................................... -20 to +60 ºC, 10 – 90 % RH (non-condensing)
Dimensions (W x H x D) .............................. 35 x 70 x 110 mm
Weight ......................................................... 135 g (Item no.: 1362463)
Legal notice
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the technical status at the
time of printing.
© Copyright 2015 by Conrad Electronic SE
5 V/DC, 4800 mA (Item no.: 1362464)
140 g (Item no.: 1362464)
V1_0815_02-ETS-Mkde