Declaration Of Conformity; Auxiliary Handle; Changing The Tool - Bosch GSH 3 E Professional Originalbetriebsanleitung

OBJ_BUCH-715-002.book Page 16 Monday, September 13, 2010 11:55 AM
16 | English
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level
105 dB(A). Conformity assessment procedure
according to Annex VI.
Equipment category: 10
Notified body:
TÜV NORD CERT GmbH & Co. KG,
Am TÜV 1, 30519 Hannover
Technical file at:
Robert Bosch GmbH, Postfach 10 01 56,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 14.09.2010
1 609 929 R01 | (13.9.10)
Downloaded from www.Manualslib.com
Dr. Eckerhard Strötgen
Head of Product
Certification
manuals search engine
Assembly
Before any work on the machine itself, pull
the mains plug.

Auxiliary Handle

Operate your machine only with the auxilia-
ry handle 6.
The auxiliary handle 6 can be set to any position
for a secure and low-fatigue working posture.
– Turn the bottom part of the auxiliary handle
6 in counterclockwise direction and swivel
the auxiliary handle 6 to the desired position.
Then retighten the bottom part of the auxilia-
ry handle 6 by turning in clockwise direction.

Changing the Tool

With the SDS-plus tool holder, simple and con-
venient tool changing is possible without addi-
tional aids.
The dust protection cap 1 largely prevents the
entry of drilling dust into the tool holder during
operation. When inserting the tool, take care
that the dust protection cap 1 is not damaged.
A damaged dust protection cap should be
changed immediately. We recommend hav-
ing this carried out by an after-sales serv-
ice.
Inserting (see figure A)
– Clean and lightly grease the shank end of the
tool.
– Insert the tool in a twisting manner into the
tool holder until it latches itself.
– Check the latching by pulling the tool.
Removing (see figure B)
– Push back the locking sleeve 2 and remove
the tool.
Bosch Power Tools