Functional Description - Bosch GSH 3 E Professional Originalbetriebsanleitung

OBJ_BUCH-715-002.book Page 15 Monday, September 13, 2010 11:55 AM
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.

Functional Description

While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The power tool is designed for chiselling in con-
crete, brick, stones and asphalt as well as,
equipped with the corresponding accessories,
for taking off tiles, plaster, rests of glue and
stucco.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Dust protection cap
2 Locking sleeve
3 Chisel adjustment ring (Vario-Lock)
4 Lock-on button for On/Off switch
5 On/Off switch
6 Auxiliary handle (insulated gripping surface)
7 Handle (insulated gripping surface)
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools
Downloaded from www.Manualslib.com
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
manuals search engine
Technical Data
Demolition Hammer
Article number
Rated power input
Impact rate min
Impact energy per
stroke according to
EPTA-Procedure
05/2009
Chisel positions
Chiselling capacity in
concrete of medium
hardness kg/h
Tool holder
Lubrication
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Noise/Vibration Information
Measured sound values determined according
to 2000/14/EC.
Typically the A-weighted noise levels of the
product are: Sound pressure level 90 dB(A);
sound power level 101 dB(A). Uncertainty
K=3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Chiselling: Vibration emission value a
2
Uncertainty K=1.5 m/s .
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
1 609 929 R01 | (13.9.10)
English | 15
GSH 3 E
Professional
0 611 320 7..
W 650
-1
0– 3500
J 2.6
12
31
SDS-plus
Oil lubrication
kg 3.5
/II
2
=16 m/s ,
h