• When operation starts, the flap direction is fixed at the vertical position in order to avoid cold draft, and return to the set the position that was set after the warm air

supply is starting.

• The flap direction will be controlled to the vertical position when the room temperature reaches the set temperature and compressor stops or when defrosting is in

operation.

• The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is supplied and the flap goes to the

set position.

When you press the AIRFLOW button once while the flap is operating, it stops swinging at the posi-

tion. Since this angle is memorized in the microcomputer, the flap will automatically be set at this angle

when the next operation is started.

• Do not expose directory to airflow from the air-conditioner for a long time.

• When in COOL or DRY operation, do not operate for a long period with the

airflow blowing straight down. Otherwise, condensation may appear on the outlet

grill and drip down.

• Do not try to adjust the flaps by hand, as the control angle may change or the flap

may not be closed completely.

Adjusting left/right air flow direction

Adjust the direction by moving the left/right air