Preparing For Operation; Specifications - Stihl Smart Connector Gebrauchsanleitung

￭ A battery which is believed to be
completely discharged can always still
deliver a dangerous short-circuit current.
If the battery is damaged or exposed to
high temperatures, fires or explosions
can be caused. This can result in serious
injuries and damage to property.
► Comply with all the statutory disposal
regulations. Dispose of discharged
batteries immediately. Keep batteries
away from children. Do not dismantle
them. Do not dispose of them by
burning.

3 Preparing for Operation

The Smart Connector can only be attached
to certain products. The Smart Connector
has to be attached at a particular place,
depending on the product.
The Smart Connector can be attached as
follows:
– via the adhesive tape on the back
– via the 2 screws and washers supplied
– via 2 cable ties
– via 2 aluminum blind rivets with a
diameter of 3 mm and of the appropriate
length for the product concerned. The
holes should be pre-drilled from the
inside of the housing using a drill with a
diameter of 3.5 mm.
STIHL recommends having a STIHL
authorized dealer fasten it using the screws
supplied, cable ties or blind rivets.
If attaching the Smart Connector to a third
party product STIHL recommends attaching
the Smart Connector via the adhesive tape
on the back.
Running time detection requires an
alternating electromagnetic field at a
distance of approx. 10 cm. An alternating
electromagnetic field is generated by
electric motors or spark plugs.
10
The following steps should be carried out in
order to fit the Smart Connector:
► Download the App from the mobile
terminal app store and create an account.
► Add products to the app and follow the
on-screen instructions.
► Using a cloth and an isopropanol-based
cleaner, clean the site described in the
App where the Smart Connector is to be
attached. The installation site must be
level, clean, dry and free from grease.
► Attach the Smart Connector as described
in the App or under https://
connect.stihl.com/.
► If gluing the Smart Connector in place:
Stick it on at room temperature and press
on firmly.
The final adhesiveness will be reached
after 3 days.
► If it is not possible to carry out these
steps: do not use the Smart Connector.
Consult a STIHL servicing dealer.

4 Specifications

– Permitted batteries: IEC - CR2032 lithium
button cell with a permissible
temperature range for use and storage of
- 30 °C to 60 °C
– Battery life: up to 12 months
– Permissible temperature range for use
and storage: - 30 °C to 60 °C
– Type of protection: IP67
– Data link: Bluetooth
terminal must be compatible with
®
Bluetooth Low Energy 4.0 and support
Generic Access Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Radiated maximum transmission power:
1 mW
– Signal range: approx. 10 m. The signal
strength depends on the ambient
conditions and the mobile terminal. The
range can vary greatly according to the
external conditions, including the
®
4.2. The mobile
0457 399 0007 A B20