Playback; Music Search System - Denon DRM-595 Bedienungsanleitung

ENGLISH

PLAYBACK

• Switch on your amplifier or receiver.
• Set the Tape Monitor switch on your amplifier or receiver to the TAPE
position.
• The numbers in the illustration below depict the order in which operation
steps are carried out.
1. Press the Power Operation switch to the
2. Press the Eject button (EJECT
Cover.
3. Load the cassette tape and close the Cassette Compartment Cover.
4. When listening to a tape that has been recorded with Dolby noise
reduction, set the Dolby NR switch (DOLBY NR) to match the system used
at the time of recording.
5. Press the Direction button (
Transport Direction
Forward
Reverse
6. Select the type of tape transport with the Reverse Mode switch (REV.
MODE).
Mode
To listen to one side only
To listen to repeat playback
of both sides
7. Press the Play button (PLAY) to begin playback.
8. Press the Stop button (
• In the continuous playback mode (Reverse Mode switch (REV. MODE)
set to ), playback of both tape sides will be repeated 5 times and
then stop automatically.
• If different types of Dolby noise reduction are used for record and
playback, playback response will be adversely effected.
• When power is turned off during tape transport, it may not be possible to
remove the cassette by pressing the Eject button (EJECT
In this case, turn on power again before you press the Eject button
(EJECT ).
5
8
ON position.
¢
) to open the Cassette Compartment
5
DOLBY NR
B OFF C
) to select the direction of tape transport.
0 1
Indicator
REV.MODE
Switch position
STOP) to stop the playback.
2
5

MUSIC SEARCH SYSTEM

2
The music search system detects blank sections (lasting for at least 4
seconds) between selections in order to locate the beginning of selections in
the forward or reverse direction.
1. To advance from the current selection to the beginning of the next
selection (CUE):
Press the Play button (PLAY), and press the Fast Forward button (
when the tape is travelling in the forward (
Press the Play button (PLAY), and press the Fast Rewind button (
when the tape is travelling in the reverse (
The tape transport indicator flashes.
The deck will skip the rest of the current selection and automatically
resume play from the beginning of the next selection.
2. To repeat playback from the beginning of the current selection (REVIEW):
Press the Play button (PLAY), and press the Fast Rewind button (
when the tape is travelling in the forward (
Press the Play button (PLAY), and press the Fast Forward button (
when the tape is travelling in the reverse (
The tape transport indicator flashes.
The deck will rewind the tape to the beginning of the current selection and
automatically resume play from that point.
This is very convenient for repeating playback of the current selection.
Notes on Music Search Operation:
The search functions operates by detecting comparatively long, blank sections
approximately 4 to 5 seconds long, in between recorded selections.
Therefore, the system may not operate normally in the following cases:
• Recordings with discontinuous speech or conversation.
• Recordings with long periods of pianissimo (softly played music).
• Recordings with long silences.
• Blank sections with a high level of noise.
• Blank sections shorter than 4 seconds.
• If noise-emitting appliances, such as electric razors, drills, refrigerators, etc.,
are operated nearby.
• REV. close to the beginning of the program or CUE close to the ending.
).
)
7
) direction.
)
6
) direction.
)
6
) direction.
)
7
) direction.