Troubleshooting - Concept OV1200 Bedienungsanleitung

EN
How to empty the water tank
1. Turn off the device.
2. Remove the tank from the unit.
3. Grasp the tank by the handle and move it gently.
4. Tilt the tank and carefully drain water out.
5. Put the tank back in the unit.
Note: Water is collected in the tank during the operation. The "Full Tank" indicator will start flashing indicating that the
water tank is full and the dehumidifier automatically stops operating.
FILTER CLEANING
Activated charcoal filter (clean approximately every two weeks)
• Clean the dust from the front of the filter with a vacuum cleaner.
• Place the filter in a ventilated area allowing the dispersion of harmful gases and germs. Do not expose to excessive
sunlight.
• The filter is fragile. Do not squeeze it too much during vacuuming.
• Do not use water to clean this filter.
• We recommend changing the filter every six months.
Warning:
1. The operating temperature of the dehumidifier is 5-32 °C. Use the appliance within this temperature range. If you
use the device outside the specified temperature range, the safety fuses will stop the operation. This is normal.
2. If the room temperature is below 5 °C, the humidity is relatively low and the dehumidifier cannot be used.
3. The built-in compressor produces heat and it slightly increases the room temperature during operation. This is
normal.
4. The dehumidifier stops operating as soon as the water tank is full.
5. The dehumidifier cannot start or stop the operation itself, in this case check the following steps:
1) Make sure both the plug and the socket are OK.
2) If it seems there is no problem, wait 10 minutes.
3) If the appliance still does not work, contact your dealer.
6. Keep a minimum distance of 15 cm between the openings of the appliance and near objects.
48
TROUBLE SHOOTING
Prior to sending the unit to the service centre, check following points:
Problem
The unit does not
work
Low
dehumidification
volume
Loud noises during
operation
The appliance
stops operating in
the room
Washed laundry is
not dry
If one of the following phenomena occurs, your appliance is OK.
Phenomenon
Operation gets interrupted for
time to time
Low dehumidification volume
The humidity in the room is still
Unpleasant smell is emitted during
operation
The unit is emitting noises during
operation
There is water in the water tank
after unpacking the appliance
OV1200 | OV1210 OV1200 | OV1210
Possible cause
Make sure the plug is not disconnected
from the electrical outlet.
Make sure the water tank is not full.
Make sure the tank is properly inserted.
Check whether the filters are dirty or not.
Make sure the air openings are not
blocked.
Make sure the unit is installed as
instructed.
Check that the room temperature is not
higher than the designated operating
temperature.
Check that the outlet of the appliance
does not aim on the laundry.
Make sure the room temperature is not
too low.
The unit is defrosting.
If the room temperature is low, the speed of dehumidification decreases. The
unit stops if the room temperature drops below approx. 5 °C or rises above
32 °C. In automatic mode, the dehumidifier will stop if the humidity drops
below 60 %.
The room is too big. Doors or windows in the room may often get opened/
closed. The dehumidifier is used in the room along with a kerosene heater
high
that emits steam.
Odours come from walls, furniture or other objects.
Circulation of the coolant can produce noises.
The water in the tank was used to test the functionality of the appliance in
the factory.
EN
Remedy
Plug the power cord plug in the wall outlet.
Drain water out of the tank.
Put the water tank in the correct position.
Clean the filters as instructed.
Remove all obstructions blocking the
openings.
Place the unit on a stable, flat surface.
As soon as the temperature drops, the
appliance will start operating automatically.
Move the laundry to the other side of the
appliance with the air inlet.
It is difficult to dry the laundry at low
temperatures.
Cause
49