Alarms And Timers; Setting An Alarm; Cancelling A Sounding Alarm; Snoozing A Sounding Alarm - PURE Evoke C-F6 Bedienungsanleitung

Alarms and timers

Setting an alarm

Evoke has two alarms which can switch the radio on and tune to a digital or FM radio station, play a
CD or sound an alarm tone.
1.\ Press the button.
2.\ Turn and press the Select dial to select 'Alarm 1' or 'Alarm 2'.
3.\ Turn the Select dial to scroll through each alarm setting. If you want to change a setting, press
the Select dial. You can set the following alarm options:
\ Enable: Turn and press the Select dial to choose when you want the alarm to repeat. The available
options are 'Daily', 'Once', 'Weekends' or 'Weekdays'.
\ Time: Turn and press the Select dial to adjust the hour of the alarm. Note: If you have set your Evoke
to use the 12 hour time format, make sure that you select the 'AM' or 'PM' version of the hour
before pressing the Select dial. Repeat to set the minutes of the alarm.
\ Mode: Turn and press the Select dial to choose between 'Buzzer', 'Internet radio', 'DAB', 'FM' or
'CD'. Note: If you select 'CD' as the alarm source and there is no CD in Evoke when the
alarm sounds, the 'Buzzer' will sound instead.
\ Preset: If you have set your alarm to tune into an internet, digital or FM radio station, turn and press
the Select dial to choose between the last radio station you were listening to or one of the stations
in your preset list.
\ Volume: Turn and press the Select dial to set the volume of Evoke when the alarm sounds. \
Save: Turn and press the Select dial to save the alarm.
Evoke's display will show the

Cancelling a sounding alarm

To cancel a sounding alarm, press any button except the Select dial. If you press the Standby
button during a sounding alarm, Evoke will enter standby.

Snoozing a sounding alarm

To snooze a sounding alarm, press the Select dial. Evoke's display will show the snooze countdown
timer and the alarm icon (
Evoke snoozes an alarm for 5 minutes. To change the default snooze time see page 7.

Setting the sleep timer

Evoke has a sleep timer that switches your Evoke into standby after a set time period. To set the
sleep timer:
1.\ Press the Menu button.
2.\ Turn and press the Select dial or use the <Select> buttons on the remote control to choose
'Main menu' and then choose 'Sleep'.
3.\ Turn the Select dial or use the < > buttons on the remote control to increase the duration of the
sleep timer from 15 to 60 minutes. Press the Select dial or the Select button on the remote
control to start the sleep timer.
Evoke's display will show the sleep icon when the sleep timer is active.
or icon to show that the alarm has been set.
or ) will flash to show how long the alarm will snooze for. By default,
EN
17