Set Emissivity - sauermann Si-HH3 Kurzanleitung

5b Connect the smartphone and the instrument (Si-TI3 only)
The Si-TI3 is automatically turned on with wireless communication activated when inserting
batteries.
• Launch Si-HVACR Measurement MobileApp application by pressing its icon.
• Press "Search for devices".
• Press the line of the required device then "Connect".
The Si-TI3 will automatically shutt-off after 15 s of non-use.
6 Display measurement
Once the instrument is connected to the smartphone, measurements are displayed.
Si-HH3 Si-PM3
7 Emissivity (Si-TI3 only)
Emissivity is a term used to describe the energy-emitting characteristics of materials. See table below
for values of emissivity of specific materials:
Aluminium 0.30
Asbestos 0.95
Asphalt 0.95
Basalt 0.70
Brass 0.50
Brick 0.90
Carbon 0.85
Ceramic 0.95
Concrete 0.95
Copper 0.95
Dirt 0.94
Frozen food 0.90
Hot food 0.93
Glass 0.85
Water 0.93
Fresh foodstuffs between 0 and 5 °C
8 Operating temperature, protection of the instruments and information about storage and batteries
• Si-HH3 / Si-TI3 / Si-TT3: from -10 to +60°C (14 to 140°F)
• Si-PM3 / Si-VH3: from 0 to 50°C (32 to 122°F)
• Si-VV3: from 0 to 40°C (32 to 104°F)
If the instrument is stored outside the operating temperature (for example in a van, a
warehouse,...) please wait for 10 minutes in its operating temperature before starting and using it.
To ensure safety, replace batteries with the same type. Not doing so runs the rise of
explosion. Dispose of used batteries according to instructions.
Si-TI3
Ice 0.98
Iron 0.70
Lead 0.50
Limestone 0.98
Oil 0.94
Paint 0.93
Paper 0.95
Plastic 0.95
Rubber 0.95
Sand 0.90
Skin 0.98
Snow 0.90
Steel 0.80
Textile 0.94
Wood 0.94
0.90
Si-VH3
Si-TT3

Set emissivity

• With the device turned on.
• Press Mode key then use Lock key
to increment or Unit key to decrease
the emissivity value.
• The emissivity can be changed from
0.10 (10E) to 1 (100E).
• Press Mode key to confirm.
• Si-HH3: IP20
• Si-PM3: IP40
• Si-TT3 / Si-VH3 / Si-VV3: IP54
Si-VV3