Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
DE
2. Product identification
The type plate serves to identify the device. The most important data can be taken from
this. The order code is used to uniquely identify your product.
Setting limits
Fig. 1 Example of type plate
The type plate must not be removed from the device!
3. Mechanical installation
3.1 Installation and safety instructions
WARNING
-
In case of increased danger of lightning strike or damage by overvoltage, a stronger
lightning protection should be planned.
-
Do not install the device in a pneumatic delivery stream!
-
Excessive dust accumulations (over 5 mm) or complete coverage with dust must be
prevented!
-
A minimum of protection class IP 20 must be ensured for the electrical installation.
Please treat this highly sensitive electronic measuring instrument carefully, both
when packed and when unpacked!
No modifications or alterations may be made to the device.
The device must not be thrown!
Only remove the packaging and, if applicable, the protective cap from the device
shortly before its installation, so as to avoid damaging the diaphragm. Be sure to
retain any protective cap supplied!
20
Type designation
Danger of injury from media escaping under
pressure
Install in an unpressurised state.
-
Depressurise the system.
-
Order code
Serial number
Werbung
Kapitel
Inhaltsverzeichnis
