Inhaltsverzeichnis
Werbung
Protection against
excess temperatures
-
Protection against
power supply failure
-
Notes
12
Your hob has a protection system for the electronic
of the timer.
Where there is high temperature in the electronic of
the timer, the message
times are alternatively displayed, and the burners will
stay switched on. If the temperature drops down to an
+
acceptable level, the
temperature reaches the maximum allowed limit, the
timer switches off all the burners of your appliance as
a safety action, the message
time of the set burners which have been switched
off are alternatively displayed. The controls are
blocked until the temperature drops down to an
acceptable level. Wait a few minutes and use again
your appliance.
If there is a power cut, as a safety action, the set
burners are switched off.
As soon as the electricity is restored, the message
P0
is displayed. In order to use again the timer,
touch any of the symbols, the display will go out
+
and your hob will be reeady to be set.
The message
the appliance is plugged in. In order to use again
the timer, touch any of the symbols, the display will
go out and your hob will be ready to be set.
When water falls on any of the sensors, the system
sends out an alarm.
The system will not work if it is handled with wet hands.
H
and the information of the set
H
message disappears. If the
H
P0
is also displayed the first time
and the remaining
Werbung
Inhaltsverzeichnis
