Inserting/Replacing The Batteries; Initial Operation - Bosch PLR 15 Originalbetriebsanleitung

Downloaded from www.Manualslib.com
OBJ_BUCH-1900-002.book Page 19 Friday, March 28, 2014 3:24 PM
Assembly

Inserting/Replacing the Batteries

Alkali-manganese batteries are recommended for the measuring tool.
To open the battery lid 4, press the latch 5 in the direction of the arrow
and remove the battery lid. Insert the batteries. When inserting, pay at-
tention to the correct polarity according to the representation on the in-
side of the battery compartment.
When the battery symbol
measurements are still possible for approx. 15 minutes. When the battery
symbol flashes, the batteries must be replaced; measurements are no
longer possible.
Replace all batteries at the same time. Only use same-brand batteries
with the identical battery capacity.
 Remove the batteries from the measuring tool when not using it
for extended periods. When storing for extended periods, the batter-
ies can corrode and self-discharge.
Operation

Initial Operation

 Do not leave the switched-on measuring tool unattended and
switch the measuring tool off after use. Other persons could be
blinded by the laser beam.
 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or var-
iations in temperature. As an example, do not leave it in vehicles for
a long time. In case of large variations in temperature, allow the meas-
uring tool to adjust to the ambient temperature before putting it into
operation. In case of extreme temperatures or variations in tempera-
ture, the accuracy of the measuring tool can be impaired.
 Avoid heavy impact to or falling down of the measuring tool. After
severe exterior effects to the measuring tool, it is recommended to car-
ry out a check (see "Checking the Measuring Tool", page 22) each time
before continuing to work.
Bosch Power Tools
manuals search engine
English | 19
appears for the first time on the display,
1 609 92A 0JX | (28.3.14)