Setting An Alarm - PURE EVOKE-1 XT Tri-Band Bedienungsanleitung

Setting an alarm

Downloaded from www.Manualslib.com
XT
EVOKE-1 Tri-Band has a daily alarm which switches the radio on (if in standby mode) and tunes to the station you have
chosen or sounds a tone. To set or change an alarm:
1. Press the Menu button to see the current alarm settings.
2. Push the Tune knob if you want to change the alarm settings.
3. Turn the Tune knob to scroll through the following settings and push to change them. The current setting is shown on
the top line of the screen.
Set alarm Set the alarm on or off.
Set time Turn the Tune knob to set the hours, push the Tune knob, turn again and push to set the minutes.
Set mode Choose between a DAB or FM radio alarm (set to lastest station tuned to in that mode) or Tone
alarm. If you set a radio alarm the volume will be whatever the volume control is set at when the
alarm goes off.
When finished, press the menu button or wait to exit. If you switch your radio into standby you will see a bell symbol
on the screen next to the clock showing that an alarm is set.
Note If you set a DAB alarm and the station is not available when it is due to go off, a tone alarm will sound instead.
When the alarm goes off, EVOKE-1
station you have chosen. You see the clock and flashing alarm icon on screen. You cancel the alarm as follows:
Radio alarm Press any button to cancel the alarm and perform the button's normal function.
Tone alarm Push the Tune knob or Standby to cancel the alarm.
All alarms will automatically stop after 60 minutes if not cancelled and your EVOKE-1
manuals search engine
XT
Tri-Band will beep (gradually increasing in volume to a set level) or tune to the
XT
Tri-Band will go into standby.
8