Viewing Minimun Temperature Recorded; Erasing Recorded Values; Operating Tips; Alarms And Warning - coldline MASTER Serie Bedienungs- Und Wartungsanleitungen

9.2 VIEWING MINIMUM TEMPERATURE RECORDED
Press key the display reads "Lo" followed by the maximum temperature value recorded.

9.3 ERASING RECORDED VALUES

View the maximum or minimum temperature using buttons
Press button .
The "rST" message flashes 3 times to confirm that values have been successfully erased.

10.0 OPERATING TIPS

When filling with food, if the operation takes more than 5 minutes, switch off the appliance and restart it
when you have finished filling.
Only fill freezers with pre-frozen products or with non-frozen products whose mass must not exceed 10% of
the total content of the compartment.
Do not use the appliance to cool hot food or food that has just been cooked.
Keep products arranged within the perimeter of the rack so as to allow correct airflow inside the
compartment.
The maximum load for each shelf is about 30 kg.
Avoid opening the door frequently when the appliance is defrosting (7.0).
11.0 ALARMS AND WARNINGS
If an alarm is triggered, the warning is provided by LED
condition is over. All alarm messages flash, alternating with the temperature, except for P1, which flashes
constantly.

11.1 LIST OF ALARMS

"P1" flashing; compartment sensor error.
• Tells you that compartment sensor is faulty or is not connected properly.
• Emergency mode is triggered automatically, which handles the compressor start and stop cycles based on
values set in the general parameters.
• If the alarm persists, contact technical assistance department .
"P2" flashing; evaporator sensor error.
• Tells you that evaporator sensor is faulty or is not connected properly.
• If the alarm persists, contact technical assistance department.
"HA" flashing; high temperature.
• Tells you that temperature inside the compartment is higher than maximum permissible value.
• The alarm ceases automatically when temperature falls back inside the normal range, when defrosting starts
or when the door is opened.
• If the alarm persists, contact technical assistance department.
"LA" flashing; low temperature.
• Tells you that temperature inside the compartment is lower than minimum permissible value.
• The alarm ceases automatically when temperature falls back inside the normal range, when defrosting starts
or when the door is opened.
• If the alarm persists, contact technical assistance department.
20
or .
, which remains on display until the alarm