Operation; Switching On; Switching Off; Set Point - coldline MASTER Serie Bedienungs- Und Wartungsanleitungen

5.0 OPERATION

5.1 SWITCHING ON

Once you have turned on the appliance's power, the control panel (4.0) automatically runs a lamp test. The
LEDs and displays come on for a few seconds, after which the display reads "OFF" (control panel goes into
Standby mode).
Make sure the appliance is in standby mode.
Press button .
Display gives the temperature inside the appliance.
Led flashes for a few minutes with the compressor off (compressor start delay).
LED stops flashing and remains steadily lit, the compressor starts and works non-stop to reach the setpoint
temperature that has been entered.
At this stage, LED may switch on and off, depending on the start temperature set for the fans in the
general parameters (except for STATIC version).

5.2 SWITCHING OFF

If leaving the appliance switched off for some time, disconnect the power cord.
Press button .
Display reads "OFF".
Control panel goes into Standby.

5.3 SET POINT

The setpoint is the temperature value the appliance is required to reach and maintain, without exceeding it
by more than 2°C.
5.4 EDITING SET POINT
Press button .
The setpoint value entered flashes on display
Use buttons and
Press button to store the value.

5.5 WORK CYCLE

Once the temperature setpoint is reached, led
temperature rises above said setpoint by 2°C. led
Example: if the setpoint is 2°C, the compressor will work to keep the temperature within the range 2°C to
4°C.

5.6 KEYPAD LOCKOUT

Make sure the appliance is working (5.1).
Hold down buttons
The keypad is locked - you can only view the setpoint and minimum and maximum.
18
to increase or decrease the setpoint until you reach the desired.
and together until the message "POF" flashes on the display.
; LED flashes.
goes off and the compressor stops. It starts again when the
lights again and the cycle is repeated.