Getting Started - Emos E5010 Handbuch

Button
Display values for sensor 1/2/3 and
CH (B*) activate cycling mode to display values
from sensors 1/2/3
SNOOZE 1. Snooze – postpone alarm by 5
LIGHT
(C*) 2. Brief screen illumination.
ALERT
Turn temperature alert on/off
(D*)
1. View MAX/MIN measured values for
UP (E*) temperature and humidity
2. One step forward in settings mode.
1. View pressure history in the last 0
DOWN
(F*)
2. One step back in settings mode.
G – hole for hanging on the wall
H – battery compartment
I – stand
Sensor Description
See fig. 3
A – LED
B – LCD screen
C – hole for hanging on the wall
D – battery cover
E – battery compartment

Getting Started

1. Insert batteries into the weather station (3× 1.5 V AAA) first, and then into the wireless sensor
(2× 1.5 V AAA). When inserting the batteries make sure the polarity is correct to avoid damaging
the weather station or sensor. Only use 1.5 V alkaline batteries of the same type; do not use
rechargeable 1.2 V batteries. Lower voltage may cause both of the units to not function.
2. Place the two units next to each other. The weather station will detect the remote sensor signal
within 3 minutes. If signal from the sensor is not detected, long press the CH button on the
weather station to repeat the search.
3. If the outdoor temperature reading disappears from the display, long press the CH button on the
weather station. The weather station resets all values and repeats the search for sensor signal.
4. If you want to have the sensor placed indoors and measure outdoor temperature and indoor
humidity, thread the wire probe under a window that is not frequently used. Frequent opening
may damage or destroy the probe. The outdoor portion of the temperature wire probe must be
anchored so as to prevent its tearing off in the wind.
5. We recommend placing the sensor on the north side of the house. The range of the sensor may
decrease substantially in areas with large number of obstacles.
6. The sensor is resistant to dripping water, however, it should not be permanently exposed to rain.
7. Do not place the sensor onto metal objects; doing so will reduce the transmission range.
8. If the low battery icon is displayed, replace batteries in the sensor or weather station.
Switching Channels and Connecting Additional Sensors
1. Select channel 1, 2 or 3 for the sensor by repeatedly pressing the CH button. Then, long-press
the CH button. The
2. Remove the cover from the sensor's battery compartment and insert batteries (2× 1.5 V AAA).
Button press
minutes
to 12 h
icon will begin flashing.
4
Button press and hold (3 seconds)
Repeat search for sensor signal and pair
sensors 1/2/3.
Set altitude and change weather
forecast icon.
Set temperature alert.
1. Erase MAX/MIN values from memory
2. Fast forward in settings.
Fast backward in settings.
F – selector for channels (CH 1, 2, 3)
G – selector for temperature units (°C/°F)
H – wired sensor with temperature probe
(1 m)