Getting Started - Emos E0300 Bedienungsanleitung

Getting Started

1. First, insert batteries into the weather station (2× 1.5 V AAA), then into the wireless sensor
(2× 1.5 V AAA). When inserting the batteries, make sure the polarity is correct to avoid
damaging the weather station or sensor. Only use alkaline batteries of the same type, do
not use rechargeable batteries.
2. Place the two units next to each other. The weather station should search for and detect
the remote sensor signal within 3 minutes. If the remote sensor signal is not detected, press
and hold the CH button to repeat the search; the
3. If the outdoor temperature value disappears from the display, repeat steps 1 and 2.
4. We recommend placing the sensor on the north side of the house. The range of the sensor
may decrease substantially in areas with many obstacles. The sensor is resistant to dripping
water; however, it should not be exposed to sustained rain. Do not place the sensor on metal
objects. Doing so reduces transmission range.
Switching Over to Another Channel and Connecting Additional
Sensors
1. Select channel 1, 2 or 3 for the sensor by shortly pressing the CH button. Then, long-press
the CH button. The
2. Remove the cover from the battery compartment on the rear of the sensor and set the
sensor switch to the desired sensor number, then insert batteries (2× 1.5 V AAA).
3. Data from the sensor will be loaded within 3 minutes.
4. If the sensor signal is not detected, remove batteries from the weather station and sensor
and repeat the process.
Radio Controlled Clock (DCF77)
After registering the wireless sensor, the weather station will automatically begin searching
for DCF77 signal for 10 minutes – the
the icon will be displayed.
During the search, no other data on the display will be updated and the buttons will be disabled.
Signal detected – the icon stops flashing and remains on the screen and the current time
is displayed.
Signal not detected – the icon is not displayed.
Press and hold the - button to repeat search for DCF77 signal.
Press and hold the - button again to stop search for DCF77 signal.
DCF signal will be synchronised daily between 2:00 and 3:00 am.
In normal conditions (at a safe distance from sources of interference, such as television sets
or computer monitors) the capture of time signal takes several minutes. If the weather station
does not detect the signal, follow these steps:
1. Move the weather station to another location and try to detect DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television
sets). The distance should be at least 1.5 to 2 m during signal reception.
3. When receiving DCF signal, do not put the weather station in the proximity of metal
doors, window frames and other metal structures or objects (washing machines, dryers,
refrigerators etc.).
4. In reinforced concrete structures (cellars, high-rise buildings etc.), the DCF signal reception
is weaker, depending on the conditions. In extreme cases, place the weather station close
icon will begin flashing.
icon will flash. After detecting the DCF signal,
5
icon will flash.