Marta MT–1103 Bedienungsanleitung Seite 13

STEAM SHOT

Use steam shot to generate a powerful burst steam that can penetrate fabric and smooth the most difficult and tough creases.
 Set thermostat to •• or ••• position.

Set steam selector to required position.

Wait till light indication is off.

Press shot-steam button.

Wait several seconds and press the button again.
CAUTION: Steam temperature is extremely hot! Avoid any contact with steam or hot water!
NOTE: Steam shot could be used only at high temperature. Stop steam shot using when light indication is on. Go on when the light indication is off.
You can use steam shot function for vertical ironing.
VERTICAL IRONING
 Set thermoregulator to •• or ••• position.

Set steam selector to required postion.

Wait till light indication is off.

Set the iron vertically and lead it along the fabric. Press shot-steam button at the same time, making pause between presses.
CAUTION: Steam temperature is extremely hot! Avoid any contact with steam or hot water!
NOTE: Steam shot could be used only at high temperature. Stop steam shot using when light indication is on. Go on when the light indication is off.
Go on ironing when light indication is off.
DRY IRONING

You could use dry ironing even if the water tank is full. Nevertheless it is not recommended to fill water tank with water if you plan to use dry ironing continuously.

Set steam selector to «OFF» position.

Set the steam iron vertically on ironing board.

Plug the appliance in.

Set required temperature with thermostat according to signs on clothes labels.

Wait till light indication is off. That means that temperature reached operational temperature.
SPRAY FUNCTION

Make sure that there is water in water tank.
 Spray function could be used with any temperature mode and in any working mode.

Press spray button.
NOTE: Use spray function for delicate facbric ironing. You could use as well damp fabric placed between iron and clothes. Don't use spray function for silk and synthetics to avoid stains
and marks.
END OF WORK

Set thermoregulator to «MIN» position.

Set steam selector to «OFF» position.

Unplug the appliance.

Turn the appliance down and gently shake to pour rest of water.
 Make sure that the steam iron is completely cool.

Roll up the power cord with the rewinder.

Always keep the iron in a vertical position.
13