Zipper Maschinen ZI-CRM40V-AKKU Betriebsanleitung Seite 27

15 TROUBLE SHOOTING
Danger due to electrical voltage! Manipulating the machine when connected to the
power source can cause serious injury or death. Always disconnect the machine from the
power supply before troubleshooting and secure it against unintentional restarting! Repair
work may only be carried out by qualified personnel!
When you are unable to carry out necessary repairs properly and/or do not have the required skills to
do so, always contact a specialist to help you in solving the problem.
Trouble
Motor does not start
Unusual, loud noises and
excessive vibrations
Poor pickup of the grass
Poor cutting result
Battery cannot charged
anymore
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-CRM40V-AKKU
WARNING
Possible cause
 Safety switch is not plugged in
 Battery is not plugged in
 Battery is not charged
 Safety switch is damaged
 Power switch is damaged
 Loosen cutting tool
 Debris on the cutting tool
 Cutting tool damaged
 Wrong cutting height
 Full grass box
 Blunt cutting tool
 To high grass
 Contact failure
 Battery damaged
TROUBLE SHOOTING
Solution
 Plug in safety switch
 plug in battery
 Recharge battery
 Check safety switch
 Check safety switch
 Tighten cutting tool
 Remove derbies
 Change cutting tool
 Set to correct cutting height
 Empty grass box
 Sharpen or change cutting tool
 Set to correct cutting height
 Check contact pins
 Change battery
27