Battery Status Light; Removing Battery; Adjusting Cutting Height - Zipper Maschinen ZI-CRM40V-AKKU Betriebsanleitung

Battery status light:

Close battery compartment. Battery condition can be checked at
any time by pressing the button beside the status lights.
4 x green = fully charged
If no light, recharge the battery

Removing battery:

Open the battery compartment. Unplug the safety switch.
Press the lock button and slide out the battery.
Start / Stop:
1. Press and hold the safety switch (1).
2. Press one of the four power switches (2).
3. Release the safety switch
4. To stop the mower, release the power switch button.
Adjusting upper handle:
1. Loosen upper handle clamp.
2. Adjust upper handle in desired position
3. Fasten the upper handle clamp
1.

Adjusting cutting height:

The cutting height is set centrally with one lever
1. Pull the cutting height lever sideways
2. Push the lever in desired positon and allow the lever to
engage into one of the slots
Slot 1: 25mm
Slot 5: 75mm
ZIPPER MASCHINEN GmbH
ZI-CRM40V-AKKU
www.Zipper-Maschinen.at
OPERATION
23