Charger; Charging The Battery - Zipper Maschinen ZI-CRM40V-AKKU Betriebsanleitung

13.3

Charger

Charging the battery:

1. Connect the charger (1) to the power supply (AC outlet) 230 V / 50 Hz
2. Insert the battery (3) into the slots of the charger and slide into place until the battery locks
into place.
3. Charge the battery
4. Once the battery is fully charged remove the battery by pressing the lock button and sliding
out of the charger
5. Li-Ion batteries have nor memory effect. A partial charge will not damage the battery.
LED- indicator light (2):
LED lights red: Charger is ready to charge but no battery is connected.
LED flashes green: Battery is charging
LED lights green: Battery is fully charged and should be removed
LED flashes red: Battery is fault or overheated
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-CRM40V-AKKU
OPERATION
24