Spin Speed Selector Dial - Zanussi F 1025 Gebrauchsanweisung

• set the washing machine to PAUSE by pressing
the START/PAUSE button;
• press the DELAY button once, the light relevant to
the selected delay goes off;
• press the START/PAUSE button again.
Important!
• The selected delay can be changed only after
selecting the washing programme again.
• The door will be locked throughout the delay time
(DOOR LOCKED light lit).
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
START/PAUSE button. After closing the door,
press the START/PAUSE button again.
The delay start cannot be selected with SPIN
and DRAIN
6 Programme progress display
When you choose the delayed start, the light
relevant to the selected delay lights up.
After the machine has started, the remaining time is
shown by the corresponding indicator light.
WASHING: when this light comes on this means
that the machine is performing the washing
programme.
END = end of programme
The END pilot light flashes in the event of operating
problems:
- 4 flashes = the door has not been closed
- 2 flashes = the machine does not empty
- 1 flash = the machine does not fill
To eliminate the problem, see paragraph "Something
not working".

7 Spin speed selector dial

This dial allows you to reduce the final and the
intermediate spin speeds or to select the NO SPIN
or RINSE HOLD (anti-crease)
Downloaded from www.Manualslib.com
programmes.
option.
manuals search engine
The speeds on the dial refer to cotton programmes.
Position 1000 (or 1200, 1400) corresponds to
900 r.p.m. for synthetics, wool and handwash and
700 r.p.m. for delicates.
Position 500 corresponds to 450 r.p.m. for delicates
and 500 r.p.m. for synthetics, wool and handwash.
NO SPIN : by selecting this option all the
spinning phases are suppressed. To be used for
extremely delicate items.
The machine will add 3 rinses on cotton
programmes and 1 rinse on synthetic
programme.
RINSE HOLD (anti-crease)
option the water of the last rinse is not emptied
out to prevent the fabrics from creasing. When
the programme has finished the phase light END
and the door light are on to indicate that the
water must be emptied out.
To do this:
turn the programme selector dial to "O"
select the drain
Using the spin speed selector dial you can
choose the desired spin. If the dial remains on
position the machine will perform the spin
speed at 400 rpm.
depress START button.
8 Programme selector dial
The selector is divided into 5 sections:
• Cotton
• Synthetic
• Delicate
• Wool
• Special programmes
O Reset programme/OFF
The selector dial can be turned either clockwise or
anticlockwise.
Position 60E corresponds to the ENERGY SAVING
programme and position
67
: by selecting this
or spin programme.
to "cold wash".