Phono Input Controls; Stereo Headphone Amplifiers (2 X) - swissonic USB Studio D Mk. II Benutzerhandbuch

A -20dB PAD switch is provided to reduce the input gain on very high input signals. If your
signal is distorting, depress the -20dB switch to adjust to a more suitable level.
The REC switch directs the line level source signal to the USB interface and allows you to
record the signal with your computer when in the drepessed position. In that case, the signal
also will be sent to the REC output on the rear panel. When in the non-depressed position the
signal is routed to the main outputs on the rear panel for live input monitoring.
4.3
Independent (2 x) rotary volume controls, line/phono switch, and a record/monitor enable
switch.
This is where you can connect up to two stereo phono/line level devices, control their input
gain, and choose either to monitor the signal directly to your main outputs for monitoring, or
to send the source to the REC outputs and subsequently to your computer via USB.
Connect your stereo (L&R) phone/line level device with a standard RCA audio cables and
turn up the volume knob to an acceptable level.
A line/phono switch is provided for each stereo pair of inputs which toggles the use of the
inputs as either a fully operational RIAA phono pre-amp or as standard RCA line level inputs.
The REC switch directs the phono/line level source signal to the USB interface and allows
you to record the signal with your computer when in the drepessed position. In that case, the
signal also will be sent to the REC output on the rear panel. When in the non-depressed
position the signal is routed to the main outputs on the rear panel for live input monitoring.
4.4
Independent (2 x) rotary monitor volume controls, and MIX/REC switch.
This is where you can connect up to two stereo headphones, control their volume, and choose
either to monitor the full monitor mix of your signals from both the front panel inputs and the
REC inputs together, or just the REC input signal from the rear panel (only what you are
recording). The MIX/REC switch toggles the monitor mode of the headphone amplifiers.
Downloaded from www.Manualslib.com

Phono Input Controls

Stereo Headphone Amplifiers (2 x)

manuals search engine
10