Care And Maintenance - Küppersbusch FWK8850.0S Bedienungsanweisung Mit Montageanweisungen

If you want to revert back and conserve energy (recommended), please press and hold the
for 5 seconds, the display will show "LF". After 4 seconds the display will revert back to normal, and
the light will automatically switch off after 10 minutes.

5. CARE AND MAINTENANCE

Before cleaning your appliance (something that should be done regularly), disconnect it by removing
the plug or by pulling the fuse on the circuit.
Before using your appliance for the first time and regularly after that, we recommend that you clean
the inside and outside (front, side and top) with warm mixed with a gentle cleaning product. Rinse with
clean water and allow to dry before reconnecting. Do not use solvents or abrasives.
When the appliance is switched on for the first time, there may be a residual odour. In that case, runt
the appliance empty for a few hours at the coldest possible temperature. The cold will kill any odours.
In case of a power cut
Most power cuts are resolved within a short time. A power cut of 1 or 2 hours will not affect the
temperature in your cabinet. To protect your wines during a power cut, avoid opening the door as
much as possible. During very long power cuts, take the necessary measures to protect your wine.
 If the appliance is disconnected or if there is a power cut, you must wait three to five minutes
before re- starting. If you try to re-start before this time, the compressor will only re-start after 3 to 5
minutes (if the temperature requires).
 When switching on for the first time or following a prolonged shutdown, it is possible that when re-
starting, the temperatures selected and those displayed are not the same. This is normal. It will
take a few hours before they stabilize.
Vacation time
 Short vacations: leave the wine cooler operating during vacations of less than three weeks.
 Long vacations: if the appliance will not be used for several months, remove all items and turn off
the appliance. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the
door open slightly: blocking it open if necessary.
Moving your wine cooler
 Remove all items.
 Securely tape down all loose items (shelves) inside your appliance.
 Turn the adjustable leg up to the base to avoid damage.
 Tape the door shut.
 Be sure the appliance stays secure in the upright position during transportation. Also protect
outside of appliance with a blanket, or similar item.
Energy saving tips
 The wine cooler should be located in the coolest area of the room (but at least at 16°C), away from
heat producing appliances, and out of the direct sunlight.
 Ensure that the unit is adequately ventilated. Never cover air vents.
 Only open the door for as long as necessary.
button
66