Using The Blender - Hamilton Beach Commercial Tango-Serie Bedienungsanleitung

A-1G91300 ENv01 11/7/01 4:34 PM Page 5
Operation
Operating the Blender–Model 91300
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
Controls
• The On/Off switch will turn the blender
I (On) for continuous operation or O (Off).
• The (Pulse) position on the On/Off
switch turns on the blender only when the
switch is pressed. When the switch is
released, the blender will stop. This will allow
you to precisely control the operation of the
blender.
• The Low/High switch allows you to select
between Low (1) and High (2) speeds.

Using the blender

Before you use the blender for the first time,
wash the container assembly and cover. Refer
to "Cleaning Instructions." Do not put the
container in the dishwasher.
To operate the blender, proceed as follows:
1. Place the blender on a clean, dry, level
surface, and set the On/Off switch to O (Off).
2. Plug the blender into an electric outlet.
3. Place the ingredients to be blended into the
container.
4. Place the container onto the base. Make sure
it rests securely on the base.
5. Place the cover and filler cap on the
container.
wWARNING
Cut Hazard
Always place cover on container
before operating blender.
Do not put spoon or other utensils
in container when blending.
Failure to follow these instructions
can result in broken bones, cuts, or
other injuries.
On (I)/
Off (O)/
Pulse
Switch
Tango Series Blender
6. Set the speed switch (on some models) to the
desired speed (1=High, 2=Low). See "Special
Blending Instructions" for blending tips.
7. To start the blender, set the switch to the
I (RUN) position. Switch to O (OFF) position
to stop the blender.
8. If you want the blender to run for short bursts,
press the (Pulse) switch. While you are
pressing the switch, the blender will run at
the selected speed. Release the switch to stop
the blender.
9. Serve the drink or food from the jar.
10. Clean the jar, cover, and filler cap as directed
in "Cleaning the Blender."
Low/High
Switch
5