Troubleshooting Guide - TEFAL OptiGrill + XL Bedienungsanleitungen

Troubleshooting guide

Problem
Button blinking
+ Indicator light solid green
+ Button blinking
+ Button
light fixed
The appliance stops during the cycle of
pre-heating or cooking.
The indicator light will blink white
+
/ / /
+ Intermittent beeping
The appliance no longer beeps.
The indicator light will blink white
+ Button blinking
+ Continuous beeping
After preheating, I placed the food inside
and closed the appliance,
indicator light stays purple and cooking
does not begin.
The appliance will activate in manual mode
+ The indicator light will blink red.
+ button , and
14
Cause
• S w i t c h i n g o n t h e
• The appliance has been
• The appliance has been
• Appliance failure.
• Appliance stored or
button blinking
• Appliance failure.
• The quantity of food
but the
• The grill was not opened
• The appliance does
• Preheating time was cut
light fixed
appliance or starting
an automatic cooking
c y c l e w i t h f o o d
a n d w i t h o u t p l a te s
preheating (manual
mode is automatically
activated).
kept open for too long
while cooking.
idle too long after the
end of warm up or keep
warm.
used in a room that is
too cold.
inside the appliance is
greater than 4 cm.
completely when placing
the food inside.
not detect food inside.
The quantity of food
is insufficient, "OK" is
blinking.
short.
Solution
• 2 possible options:
– Choose the temperature setting by
pressing the
press OK. Allow to cook, but you
must monitor the cooking (manual
mode).
– stop the appliance, remove the
food, close the appliance properly,
re-program the appliance and wait
until end of preheating.
• Disconnect the appliance from the
outlet and leave for 2-3 mins., restart
the process. The next time you use the
appliance, make sure you open and
close it quick for best cooking results. If
the problem occurs again contact your
local Tefal customer service.
• D i s c o n n e c t a n d r e c o n n e c t y o u r
appliance and immediately restart a
preheat cycle. If the problem persists,
contact your Customer Service.
• Unplug the appliance and contact
customer service.
• The quantity of food should not exceed
4 cm.
• Open the grill completely and close it
again.
• Confirm cooking activation by pressing
the button .
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the grill,
select the new cooking programme you
wish to use and wait for the preheating
cycle to finish.
button and then