g
4.2.2 Shred paper
4.2.3 Reverse run mode
4.2.4 Emptying the bin
4.2.5 Switching off the device
10
Downloaded from
www.Manualslib.com
■
Insert the paper into the centre of the feed shaft (4). The cutting
rollers are switched on automatically.
■
Let go of the paper. The device switches back to standby mode
after shredding is completed.
NOTE!
►
Empty the bin frequently in order to prevent damage to the
device.
NOTE!
►
These modes serve to remove any blockages in the cutter
system.
■
Slide the operating switch (2) to the "Rev" position. The rollers of
the paper cutting system rotate in the opposite direction.
■
Slide the operating switch (2) to the "Auto" position.
■
Switch approximately three times successively between the posi-
tions "Rev" and "Auto".
■
Switch off the device and remove the jammed paper or plastic card
from the feed shaft (4).
■
To switch the device off, slide the operating switch (2) to the "Off"
position.
■
Lift the Document shredder attachment (1) ff of the waste bin (7).
■
Empty the bin.
■
Put the Document shredder attachment (1) back on the waste bin
(7).
■
Slide the operating switch (2) to the "Off" position.
manuals search engine
Basic S7A