Accessories - Sharp SJ-BA05DTXK2-EU Bedienungsanleitung

CHAPTER -3: USING YOUR FRIDGE FREEZER

Accessories

Bottle holder (In some models)
In order to prevent the bottles to slip or fall over you can use the bottle holder. You can also prevent
making noise that will be done when you open or close the door.
Chiller shelf (In some models)
Humidity Controller (In some models)
When the humidity controller is in the closed position, it allows fresh fruit and vegetables to
be stored for a longer time.
In the event the crisper is full, the fresh dial that is located in front of the crisper, should be
opened. By means of this, the air in the crisper and humidity rate will be controlled and the
shelf life will be extended.
If you see any condensation on the glass shelf, the humidity control should be placed into
the open positions.
Ice tray
• Fill the ice tray with water and place in freezer compartment.
• After the water completely turned into ice, you can twist the tray as shown below to get the ice cube.
Adapti-Lift Door Shelf (In some models)
Fig.1
Note: Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Visual and text descriptions on the accessories section may vary according which model you have..
Keeping food in the chiller compartment instead of the freezer or refrigerator compartment
allows food retain freshness and flavour longer while preserving its fresh appearance. If the
chiller tray becomes dirty, remove it and wash with water.
(Water freezes at 0 °C, but foods containing salt or sugar require lowered temperatures to
freeze)
Normally people use the chiller compartment for raw fish, rice, etc...
Do not put foods you want to freeze or ice trays in order to make ice.
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
EN -8-
Fig.2