Connecting The Audio Cable - AEG DVD-R 4518 Bedienungsanleitung

Starting up Themen
Connecting the
Audio cable
Fig. 2/20
Fig. 2/15
56
05-DVD-R 4518 AEG - GB 56
You can choose from three transmission methods for audio signals.
You must generally choose fi rst whether you would like to have the
sound coming from your TV, or through a Stereo or 5.1-Amplifi er.
The Audio cable must then be connected to the TV or an amplifi er
accordingly.
NOTE:
If your amplifi er is equipped with a digital output, you should use the
amplifi er. You will experience a much better audio quality, and the
installation is much easier.
Stereo Output
Connect the two audio leads for the right-hand and left-hand sound
channel to your playback device or your amplifi er.
1. Plug the Audio jacks into the sockets on the back of the player.
2. Plug the Audio jacks into the corresponding sockets on your replay
device or your amplifi er.
5.1-Audio signal Output
You can obtain a particularly natural surround sound effect using an
audio output by means of a 5.1 audio signal.
This method uses 6 speakers. Four of these speakers are placed in
the four corners of the room. One speaker is positioned close to the
replay device. The sixth speaker serves the output of very low tones.
With this arrangement of speakers a very natural stereophonic sound
is achieved.
If your amplifi er has no digital input you need six cables to transmit the
analogue 5.1-Audio signal.
Proceed as follows:
1. Plug the Audio jacks into the sockets on the back of the player.
Make sure that the jacks are correctly arranged:
- (1) Connection for Subwoofer: Bass
- (2) Connection for Center speaker
- (3) Speaker rear right
- (4) Speaker rear left
- (5) Speaker front right
- (6) Speaker front left
2. Plug the Audio jacks into the corresponding sockets on your replay
device or your amplifi er.
05.07.2006, 10:31:10 Uhr