Connecting The Video Cable - AEG DVD-R 4518 Bedienungsanleitung

Connecting the
Video cable
Fig. 2/24
Fig. 2/26
Fig. 2/19b
Fig. 2/19a
05-DVD-R 4518 AEG - GB 55
The video cable transmits the video data from your DVD recorder to
the TV or the Video-Projector.
There are four different ways of connecting the DVD recorder with your
TV/Video-Projector. Select one of these possibilities to suit your replay
unit.
NOTE:
If you do not use a SCART connection it is necessary to make an
additional audio connection for the transmission of the audio data
(i.e. the sound).
SCART OUT
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the
player.
2. Plug the SCART jack into the corresponding socket on your replay
device.
Component Video
Connection using a Component Video cable ensures a very high
replay quality.
Component Video transmits only Video signals.
1. Plug each of the three jacks into the corresponding sockets on the
DVD recorder.
2. Plug the jacks into the corresponding socket on your replay device.
Select the menu „System Settings – General": Here you can
change the settings „Progressive/Line Interlacing" and „YUV/RGB"
on the playback device that you have connected. Please see the
operating instructions of the connected device for the correct
setting.
S-Video Output
A connection with an S-Video cable guarantees very good playback
quality.
With S-Video only video signals are transmitted.
1. Plug the S-Video jack into the socket on the back of the player.
2. Plug the S-Video jack into the corresponding socket on your replay
device.
Composite-Video Output
Composite-Video is used to transmit both Video and Audio data.
1. Plug the Composite-Video jack into the socket on the back of the
player.
2. Plug the Composite-Video jack into the corresponding socket on
your replay device.
Starting up Themen
55
05.07.2006, 10:31:09 Uhr