General Instructions; Connection And Operation - LD Systems MAUI11MIX Bedienungsanleitung

SETUP, CONNECTION AND STARTUP:

GENERAL INSTRUCTIONS

Before startup, the subwoofer of the LD Systems MAUI11MIX PA system must be placed upright on its rubber
feet, on a flat surface. Never operate your system on a trolley, as there is a risk that the entire system might be
unstable. Accidents and damage may result. The cooling of the power amplifier is via the vents in the connector
panel on the back of the subwoofer. To ensure adequate cooling, during operation a minimum distance of 50 cm
must be maintained between the back of the subwoofer and other objects such as walls for example.
Please ensure the correct connection of audio and power connections for the system and all connected devices
such as mixers, CD players, etc. Use only undamaged cables of suitable diameter and always unwind cable reels
completely. If necessary, use cable bridges to avoid tripping over loose cables. Never place the device directly on
an edge. Do not place the subwoofer on a table. To avoid unwanted background noise when turning on connected
devices, always turn on the system last and turn it off first.
SETUP
The LD Systems MAUI11MIX PA system consists of two components:
A. a subwoofer with integrated electronics for both system components.
B. an array column with eight 3" speakers, a tweeter and multi-pole connections in the column foot.
After the subwoofer is placed in the desired position, the array column is attached to the subwoofer. Two sturdy
steel pins provide for optimal alignment of the multi-pin connectors on the two components.

CONNECTION AND OPERATION

The device allows both the volume of the entire system and the volume of the subwoofer in relation to the total
volume to be adjusted separately. Source devices can be connected using both balanced and unbalanced cables
(XLR / 6.3 mm jack / RCA). The integrated 3-channel mixer offers a microphone input, a high-impedance instrument
input for an electric guitar for example, and inputs for source devices with line level.
6
Downloaded from www.Manualslib.com manuals search engine