Sequential Programming - Fermax DUOX Plus Installationshandbuch

SEQUENTIAL PROGRAMMING

Only 1 operator is required.
This mode allows call codes (addresses) to be assigned sequentially in whatever order you require.
The steps to be followed are detailed below:
1. Previously confi gure the panel as MASTER panel, (see previous pages).
2. Select the «sequential button programming» mode on the amplifi er.
Press the SW1 button and hold for 10 seconds until you hear a «beep.» and holding for 5 more
seconds until you hear a double ''beep'', the Mode Led (DL2) is activated to indicate that we
entered in an sequential programming mode (slow blink: 1 fl ash / second 50%).
3. Assign the new addresses to each button:
Press the call buttons in whatever order you wish to assign the codes on the entry panel, starting
with 0, and running sequentially upward.
- 1st Press = Code 0.
- 2nd Press = Code 1.
- 3rd Press = Code 2.
- and so on.
The amplifi er stores each of the buttons' new call codes.
4. Exit Programming:
Press the SW1 amplifi er's «button programming» button again.
The amplifi er automatically exits programming mode following 1 minute of inactivity.
Notes:
• If you want to program the buttons without starting with number 0 or changing the number as you program, press the
button or confi gure it until reaching the value of the account you want to assign.
- Example: if you want to assign the values 1, 5,10 to the three buttons on the panel, press the fi rst button twice, the
second 4 and the third 5 times.
• A button can be confi gured with Code 0 to make a call to the Guard Unit (if available).
RESETTING the Mapping on button panels
To reset the mapping:
- remove the power
- power the amplifi er with the SW1 programming button by long pressing for 5 seconds, maintaining
it pressed until you hear a confi rmation "beep-beep" .
7
DUOX PLUS