Inverse Programming - Fermax DUOX Plus Installationshandbuch

INVERSE PROGRAMMING

2 operators are required.
This mode allows you to assign non-sequential call codes (addresses).
The steps to be followed are detailed below:
1. Previously confi gure the panel as MASTER panel, (see previous page).
2. Program the telephone locally and independently via an entry panel or Guard unit (when
available). See the NOTE.
3. Enter in the «inverse button programming» mode on the amplifi er:
Press the SW1 button and hold for 10 seconds until you hear a «beep.» Stop pressing the SW1
button. The Mode Led (DL2) is activated to indicate that we entered in an inverse programming
mode (slow blink): 1 fl ash / second 10%).
4. Assign the new addresses to each button:
4.1.Press the telephone programming button; you will hear a programming entrance tone and
upon picking up you enter in conversation with the master outdoor panel.
4.2.With the telephone hang up, on the entry panel press the call button associated with that
telephone (homes).
The call code previously programmed on that telephone will be assigned to the button (it will
be stored on the amplifi er).
Repeat step 4 with all the home telephones-buttons on the system.
Note:
- If in inverse confi guration mode you press a button without having received access to programming from the telephone,
the amplifi er emits an error bop.
.
5. Exit Programming:
Press the SW1 amplifi er's «button programming» button again.
The amplifi er automatically exits programming mode following 5 minutes of inactivity.
Note:
• Depending on the range of call codes, you have to confi gure the outdoor panel (amplifi er) as needed.
If all telephones:
- Have the same block and sub-block address (BBSSNN) the panel is confi gured as a sub-block (or block) with those
values.
- Only coincide with the block address, it is confi gured as a block panel.
- Differ in the block number, it must be confi gured as a general entrance.
Confi guration - Programming the Amplifi er
The DUOX PLUS amplifi er can be confi gured to allow for the operation as a general entrance, block entrance or sub-
block entrance.
• The DUOX PLUS system uses 6 digit house telephone addresses.
• These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this hierarchy since the system adapts to the installation´s
needs.
6
DUOX PLUS