Inhaltsverzeichnis
Werbung
5 Maintenance
5.1 Impeller
※ Replace the Impeller if the old one gets worn or damage.
Guide Vane
Guide Vane
Step 1
※ Rotate Guide Vane clockwise
to remove from the iCleaner Rover.
(Pic.5.1.1)
Step 2
※
Use a Phillips Head Screw
Driver to remove the bolt in the
I m p e l l e r a c c o r d i n g t h e
diagram.(Pic.5.1.2)
Step 3
※
Replace the new Impeller
and assemble Impeller and
Guide Vane
- 11 -
4.3 Proper Shut Down and Care
4.3 Proper Shut Down and Care
2
2
2
2
2
2
3
3
3
3
3
3
Pull
4
6
(2) Clean iCleaner Rover: invert the iCleaner Rover gently onto the floor,
unlock the Latch on the Base Plate (Pic4.3.2) and remove the Filter Bag from
Base Plate, clean the Filter Bag (Pic.4.3.3). Once clean the Filter Bag on its
frame, reassemble the Base Plate and put it back into the iCleaner Rover once
the Filter Bag is dry.
(Note: when re-fitting the Filter Bag to the Base Plate, please ensure the long
sides of the Filter Bag are smooth to ensure an easy fit into the base of the
iCleaner Rover.)
OPEN
(1) To Shut Down the iCleaner Rover:
turn the "
" on the Power Box to the
off position, once the iCleaner Rover
finishes working, pull the Floating
Cable slowly until the Handle emerges
from the water (Pic.4.3.1), and then pull
the iCleaner Rover out of the pool by its
Handle.
Werbung
Kapitel
Inhaltsverzeichnis
