Inhaltsverzeichnis
Werbung
6 Troubleshooting and Warning Lights
Common Fault
Reason
The Socket is
not plugged in
iCleaner Rover
doesn't work
Connection is wrong
Impeller is jammed or
dirty
Weak pumping
Impeller is damage
Filter Bag is full
Drive Belt is loosen
iCleaner Rover is
or broken at one side
turning to one side
when it moves
The Filter Bag is full
Filter Bag is full
Drive Belt is
iCleaner Rover will
loosen or broken
not climbs wall
Sponge Wheel wear
Axis Sleeves wear
The Sponge Wheel
don't soak enough
iCleaner Rover will
not sink to the
bottom of the pool
It has air inside
the machine
Dirt is coming
Belt of Filter Bag is
through the
loosen or broken.
Guide Vane.
Note: The Power Box MUST BE DISCONNECTED from the Power Supply prior to
conducting any maintenance on the iCleaner Rover. Contact your local distributor, or place of
purchase for problems not covered in Trouble Shooting Guide.
Solution
Remarks
Plug in the Power Lead
Check the connection
Clean the Impeller
Replace the Impeller
Clean the Filter Bag
Replace the Drive Belt
Please turn
Clean Filter Bag
off the power
Clean the Filter Bag
before you
Replace the Drive Belt
perform any
maintance
Replace the Sponge Wheel
on the
Replace Axis Sleeves
iCleaner Rover
Hold iCleaner Rover in
water and make sure
Sponge Wheel soak
enough, normal time is
about 5-15 minutes
Wobble iCleaner Rover and
make sure air released
Replace broken Filter Bag
- 17 -
This appliance can be used by children aged from 8 years and above and persons
with reduced physical,sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer,its service
agent or similarly qualified persons in order to avoid a hazard.
2 Product Overview
2.1 Functions
◇ Automatic Cleaning: the default mode is automatic, however, this can be overridden using the
Remote Control. When the Remote Control is not being used, the iCleaner Rover will return
to automatic mode.
◇ Overall Cleaning: the iCleaner Rover not only cleans the floor of your pool, it also cleans the
wall, at the same time, the iCleaner Rover will filter water, and the dirt will be collected into
Filter Bag.
◇ Timing Cleaning: you can select one of three cleaning time with Remote Control (0.5h, 1h or
2 h). The iCleaner Rover will shut down automatically when the selected cycle time is over.
The power box must be turned off manually.
◇ Manual Cleaning: the Remote Control can be used to clean specific areas immediately.
◇ Self Protection (out of water): Impeller decelerates to a stop in twenty five seconds if the
iCleaner Rover senses it is no longer in water, to prevent personal injury and to protect the
water pump.
◇ Stop Protection: the iCleaner Rover will stop if foreign matter retards the Impeller.
2.2 Product Parameters
Model
Input Voltage
Rated Power
Cycle Time
Floating Cable Standard Length
Filter Bag
Water Pump Capacity
Moving Speed
Grade of Waterproof
Optimum Storage Temperature
Optimum Working Temperature
Dimension（L*W*H）
Packing Measurement(L*W*H)
Gross Weight
- 2 -
iCleaner Rover
100~240VAC, 50-60Hz
200W
0.5Hr/1Hr/2Hrs
15m
μm
70
3
18m /h
15m/min
Host: IP68
0~40℃
10~32℃
462.5*453*282mm
574*574*413mm
20.6kg
Werbung
Kapitel
Inhaltsverzeichnis
