Safety Warnings - Zoef Robot Pieter ZB19Z Handbuch

1 Safety Warnings

Please read this manual carefully before using the iCleaner Rover.
Before performing maintenance or service on the iCleaner Rover please
ensure the power is disconnected to avoid personal injury or property loss.
The iCleaner Rover is designed for use in swimming pools only. Any
other use is prohibited and will void manufacturers' warranty.
Do not swim in the pool whilst the iCleaner Rover is in use in order to
avoid personal injury.
Do not allow the Power Box to come in contact with water, and it is
recommended to be placed in a shady, dry and ventilated area.
When in use, the Power Supply and Caddy Cart must remain 3 meters
away from the edge of the pool.
Do not use the iCleaner Rover if there is a chance of thunder storm to
avoid personal injury.
Users are only permitted to perform maintenance described in this manual.
Any tampering with the Motor Box or Power Supply will void the
warranty.
Ensure the iCleaner Rover is fully submerged before turning the Power
Box on.
If the iCleaner Rover is not going be used for a long time, make sure to
disconnect the power, keep it clean and put it in a safe, dry and
well-Ventilated area.
If the iCleaner Rover stops working, please refer to
"Troubleshooting". If you cannot find the root cause, please contact your
local distributor.
The optimum working temperature for the iCleaner Rover is between10℃
and 32℃, avoid direct sunlight when not in use.
The iCleaner Rover is suitable for the swimming pools no deeper than 3
meters.
Lift the iCleaner Rover out of the water using the robot handles, do not lift
the iCleaner using the Floating Cable. Lifting via the cable voids warranty.
- 1 -
Indicator
Indicator
light
light
Green light
Green light
flashing
flashing
Yellow light
Yellow light
flashing
flashing
Blue light
Blue light
flashing
flashing
Blue and green
lights flashing
Blue and green
lights flashing
at the sametime
Blue 、 green
and ellow Blue 、 green
y
and yellow
lights flashing
lights flashing
at the sametime
section 6
Solution
Failure
Failure
1.Check whether the impeller is damaged;
2.Check whether the water pump motor is working;
The iCleaner
Water
3.Put the robot in the water.
has stopped Return the robot to deeper water and restart
protection
due to lack
of water
1.Check whether water pump motor and impeller
Water pump
about exceptions
The Motor Pump
motor
inside the robot
Contact the supplier for support
overheating
has over heated
2.After waiting for temperature cooling to electring
The roboter
1.Adjust the machine to the level state.
Turn the iCleaner over, and restart using
The robot is
turned over
the Remote Control or Power Switch
upside down
Walking motor
The Walking
1.Check the Walking Motors, Drive Belt and
1.Check whether travel mechanism about exceptions.
(Drive Wheel)
overload
Tracking Belts for debris or damage.
Motors are
2. Clear bebris or replace parts parts and restart
over loaded
the iCleaner Rover.
Water pump
1.Check whether water pump motor and impeller
1.Turn the robot off, check the Impeller for debris,
The Water Pump
motor
about exceptions.
or damage.
is over loaded
overload
2.Clear or replace Impeller, then restart the iCleaner.
- 18 -
Solution