Installation And Connection; Operating; Prior To First Use - Bartscher PRONTO 20 Bedienungsanleitung

•
Do not lay the cable over carpets or heat insulations. Do not cover the cable.
Keep away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
unit directly to the wall socket; do not use any extension cords or power strips.
•
Place the unit so that the plug is easily accessible and can be quickly removed from
its socket in case of necessity.

5.3 Operating

Prior to first use

•
Before the first use the device and accessories should be thoroughly cleaned (see
Chapter 6.2 „Cleaning").
•
Slide the rack into the oven and attach it on
the hooks by the door (see the figure).
•
Place the ceramic stone on the rack.
•
Insert the crumb tray into the hole under the
door during baking to collect dripping sauce,
fat or crumbs.
Downloaded from www.Manualslib.com
WARNING! Hazard via electrical current!
manuals search engine
- 23 -