Automatic Search - JGC -WE-055 Bedienungsanleitung

• If you have selected the SW frequency range, you can spring over to the
• Use the manual method to fine-tune weak or distant stations which cannot be

Automatic search

• Hold the MIN- (13) or HOUR+ button (12) firmly for approximately 2 seconds to
• Note: During the search, the sound is turned off.
Direct input of a radio station frequency
• Example: You would like to directly enter the frequency FM 87.5MHz.
• Press the ENTRY button (15) to begin with the frequency input.
• Press the number keys (17) 8, 7 and 5 one after another. Confirm your input
Notes:
• If you do not press any buttons for approximately 7 seconds, the display (6)
• If you see "Err" on the display (after confirming your entry with the ENTRY
JGC-WE-055-IM-DE-EN-V2.indb 33
Downloaded from www.Manualslib.com
desired frequency with the METER button (11). Then press the MIN- (13) or
HOUR+ button (12) to set the precise station frequency.
recognised from the automatic method.
find the next lower or higher station. By pressing the same buttons, the search
can be stopped. Repeat the search until the desired station has been found.
with the ENTRY button.
changes to its previous display. Then you have to press the ENTRY button
again.
button), the frequency given is outside of the selected frequency range. Enter a
valid frequency.
manuals search engine
RADIO OPERATION
33
19/01/2010 1:51 PM