Radio Operation; Manual Search - JGC -WE-055 Bedienungsanleitung

size: 100x145mm

RADIO OPERATION

Antenna
• The device is equipped with a telescopic antenna (21) for FM and short-wave
• A ferrite antenna has been built into this device for MW (medium-wave) and
Switching radio on and off
• Make sure that the keylock is switched off.
• Press the ON button (8) to switch on the radio. The frequency range and set
• Press the ON button again to switch the radio off. The time will then be shown
• Note for mains operation: The ON button does not separate the device from
Select frequency range
• Press the BAND/WAKE button (16), to select from four frequency ranges: FM;

Manual search

• Stations can be searched manually by pressing the MIN- (13) or HOUR+ (12)
• Each press of the button decreases or increases the device frequency by
• For MW, depending on the setting of the 9K 10K switch (22) it is set back to
32
JGC-WE-055-IM-DE-EN-V2.indb 32
Downloaded from www.Manualslib.com
(SW) reception. Pull the telescopic antenna out and turn it into the direction in
which you receive the best reception.
long-wave (LW) reception. Set up the device so that the station can be received
in the best possible sound quality.
station frequency are shown on the display (6).
on the display.
the mains supply. Pull the AC adapter from the power outlet to separate the
device from the power supply.
MW (medium-wave); SW (short wave) and LW (long-wave).
button several times.
0.05MHz for FM, 0.005MHz for SW and 1KHz for LW.
9KHz or 10 KHz. As a rule, the 10 KHz setting is used only in USA.
manuals search engine
19/01/2010 1:51 PM