Turning Off The Power Automatically When There Is No Input Signal (Power Saving Function) - Sony PFM-500A1WU Bedienungsanleitung

Turning Off the Power Automatically When There Is
No Input Signal (Power Saving Function)
This unit automatically turns off the power after
certain period if there is no input signal from the
RGB1 or RGB2 connectors. (Power saving function)
1
Press MENU.
The main menu appears on the monitor screen.
M A I N M E N U
P I C C O N T R O L
P I C S I Z E
C O N F I G
M E M O R Y
R E M O T E
S T A T U S
S E L E C T
2
Press >/. to move the cursor (z) to "CONFIG"
and press ENT.
The CONFIG menu appears on the monitor screen.
C O N F I G
V E N H A N C E
H F I L T E R
D I S P L A Y
P O W E R
L A N G U A G E
S E L E C T
3
Press >/. to move the cursor (z) to "POWER
SAVE" and press ENT.
The following menu appears on the monitor
screen.
P O W E R S A V E
4
Press >/. to select the period to turn into the
power saving mode.
OFF: The power saving function does not work.
5 m: Turn into the power saving mode after five
minutes if there is no input signal.
10 m: Turn into the power saving mode after 10
minutes if there is no input signal.
The power indicator flashes when the unit is in the
power saving mode.
30 30
(EN)
Downloaded from www.Manualslib.com
C A N C E L
ENTER MENU
: O N
: A U T O
: O N
S A V E : 5 m
C A N C E L
ENTER MENU
: 5 m
manuals search engine
To cancel the power saving function
• Input the sync signal again.
• Press the u switch on the control panel or the
POWER switch on the Remote Commander.
Signal specification for using the power
saving function
RGB1: When the sync signal is connected to the HD/
COMP IN connector.
RGB2: When the sync signal is connected to the
13th pin of the RGB IN (D-sub 15-pin) connector.
Notes
• The power saving function does not work when the
signal is input from the LINE connectors.
• If the sync signal is not connected to the HD/COMP
IN connector, the unit does not turn on even if the
sync signal is input. Be sure to set POWER SAVE to
OFF when only the RGB signal or component signal
is connected.
• If the sync signal is not connected to the 13th pin of
the RGB IN (D-sub 15-pin) connector, the unit does
not turn on even if the sync signal is input. Be sure to
set POWER SAVE to OFF when only the RGB
signal is connected.