Herunterladen Inhalt Inhalt Diese Seite drucken

MTD T/120 Gebrauchsanleitung Seite 14

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 31
NOTE: This unit is shipped without gasoline or oil. In
order to avoid damage to the unit, refer to Oil
and Fuel Information to put oil and gas in the
crankcase before attempting to start it.
NOTE: Before setting up your cultivator, disconnect the
spark plug wire from the spark plug.
Positioning the Handlebars
1. Loosen the two knobs on the inside of the
handlebars (Fig. 1).
2. With the unit upright, swing the handlebars up into
the operating position (Fig. 1).
NOTE: Take care not to pinch the throttle cable or
switch wires when positioning the handlebar.
3. Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.
RECOMMENDED OIL TYPE
Use high quality oil formulated for use in 2-cycle, air-
cooled engines. Mix the oil according to the instructions
on the 2-cycle engine oil container, 40:1 (2.5 %).
RECOMMENDED FUEL TYPE
Always use clean, fresh, unleaded petrol (gasoline).
14
ASSEMBLY INSTRUCTIONS
OIL AND FUEL RECOMMENDATIONS
Adjusting Tine Depth
Tine adjustment will vary depending on the type of soil
being cultivated and how it will be used. Generally,
adjusting the tines to break the soil 4 to 6 inches is
recommended for most gardens.
Adjust the tines as follows:
1. Stop the engine and disconnect the spark plug wire.
2. Loosen (do not remove) the two wing nuts (5) on the
tine guard (4) (Fig. 3).
3. Slide the wheel down for shallower and up for
deeper tine penetration.
4. Once the tines are in the desired position, tighten the
wing nuts, making sure that the carriage bolts are
seated properly through the bracket (Fig. 4).
5. If the tine depth is not correct, repeat steps 2 to 4.
6. Reconnect the spark plug wire and continue use.
OIL AND FUEL MIXING INSTRUCTIONS
Old and/or improperly mixed fuel are the main reasons
for the unit not running properly. Be sure to use fresh,
clean unleaded fuel. Follow the instructions carefully for
the proper fuel/oil mixture.
Thoroughly mix the proper ratio of 2-cycle engine oil
with unleaded petrol, 40:1 (2.5 %). Do not mix them
directly in the tank.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis